i have a 1994 chevy s10 with a 2003 5.3 with a cam and a bunch of other stuff i can provide info on if needed for this question. It is common for similar vehicles to have multiple transmission options available from the factory.Hello. These transmissions can be found in the following vehicles however you should double check your application with the 16 bolt pan count. The 4L60-E was found in the full range of General Motors vehicles including, Buick, Cadillac, Chevrolet, GMC, Hummer, Isuzu, Oldsmobile, Pontiac, and SAAB. The 4L60E will have a round plug with 11 wires. The non-electric shift will have a square wire plug with 2-4 wires. If unsure of your model, the 4L60E can be differentiated by looking at the wire plug going into the transmission. 1992-1993 are cross-over years, so your vehicle could have the earlier non-electronic transmission instead. The 4L60E and its variants were in production from 1992-2013 and can be identified by the square 16 bolt oil pan and 4 forward gears. Along with fixing these common problems, you'll also see an increase in the life of your transmission due to the reduced slippage. This shift kit has a newly designed isolator converter valve that works perfect in worn bores without special tools or machining. Reduces forward and low reverse clutch burnup.Fixes harmonic bounce that wears out pump and valves.The Transgo shift kit included in this kit, corrects prevents, or reduces the following complaints. This converter has a stock stall speed and will be fine for up to 500 hp
The torque converter that comes in this kit is balanced and pressure tested and has the heavy duty brazed turbine and Torrington bearings.
Remember to soak all of your clutches in transmission fluid for thirty minutes before you install them. New master rebuild box kit for the 1993-up GM 4L60E 4L65E 4L70E 4L75E M30 automatic transmission.Ī Transtec overhaul set with every rubber seal, gasket, o-ring, metal clad seals, and Teflon sealing rings that you'll need to complete your rebuild
0 kommentar(er)
